|
|
| Author |
Message |
jonnyD
Joined: 14 Jan 2015
Posts: 1
|
 Posted: Wed Jan 14, 2015 11:22 pm Post subject: Pen path selection doesn't match my anchors |
 |
|
I'm a newbie using the pen tool. I outlined a section on a photo (left photo). When I right-clicked to make the selection, the result was not where all the anchors were (right photo). It crisscrossed all over the place. Why is that? See attachments.
| Description: |
| Here is the path created with the pen tool and the resultant selection. |
|
| Filesize: |
112.12 KB |
| Viewed: |
410 Time(s) |
|
|
|
|
|
|
 |
hawkeye
Joined: 14 May 2009
Posts: 2377
Location: Mesa, Az
OS: Windows 7 Pro 64 bit
|
| Posted: Thu Jan 15, 2015 11:22 am Post subject: |
|
|
I can't say for certain why you got that result as I didn't see how you drew the path, but it's appears that you may not have all the points connected and that you actually have more than continuous single path.
However I can say for certain that are using WAY TOO MANY points. It isn't necessary to use that many, at least not for the image you posted.
The path that I posted would give you roughly the same result. As you can see it doesn't require anywhere near the number of points that you used.
| Description: |
|
| Filesize: |
30.01 KB |
| Viewed: |
404 Time(s) |
|
|
|
|
|
|
|
|
